close
close

How To Cut Aluminum Soffit. If you use a good set of sheers, there should be very little crushing or it will be hidden. Measure and cut soffit panels at a 45° angle to match the length needed for the corner pieces.

How to Safely Remove Vinyl Siding HGTV
How to Safely Remove Vinyl Siding HGTV from www.hgtv.com

Fasten the pointed end at the corner of the fascia board using staples or 1” aluminum trim nails. Cut aluminum fascia, soffit and drip edge to width by scoring it with a sharp utility knife.cut bottom flange and bend 1” of end to make lap fold and form box at corner.cut the soffit panel at your measurement mark with the circular saw.cut the soffit panel at your measurement mark with the circular saw. It saved me countless hours of work.

The Use Tin Snips Or A Dremel Tool.

They did not believe me here at work and used a blade designed for cutting plywood and turned it backwards. Measure and cut soffit panels at a 45° angle to match the length needed for the corner pieces. Cut aluminum fascia, soffit and drip edge to width by scoring it with a sharp utility knife.

You Could Use Metal Snips, But This Method Yields A Cleaner, Straighter Cut.

Cut aluminum fascia, soffit and drip edge to width by scoring it with a sharp utility knife. We may have some access to the soffit from above, perhaps enough to. How to cut metal sofit?

This Jig Can Also Be Used To Easily Cut Vinyl.

Spray some wd40 on the blade to keep from gumming up with aluminum. About press copyright contact us creators advertise developers terms privacy policy. You could use metal snips, but this method yields a.

All You’ll Need Is Your Saw And A Simple Jig.

Then either peel back the material or bend it back and forth until it snaps off. I installed aluminum fascia and soffit on my camp (@ approx 150 linear feet) last fall. The soffit is not horizontal, it slants upward.

I Show You A Simple Wooden Jig I Built Myself To Cut New Aluminum Soffit.

I threw on a standard carbide blade facing the normal way and it cuts fine. Guide the score with a straightedge for flat work. The jig just has to be able to allow you to slide the soffit in and hold your saw so that you can run it across the workpiece.

How To Cut Aluminum Soffit
Tagged on:

Leave a Reply

Your email address will not be published.