close
close

How To Light A Pilot Light On A Furnace. Keeping this in view, where is the pilot light on my furnace?light the long match and place the lit end on top of the pilot light stem.make sure the thermostat is set to the heat mode. If your pilot light is out, make sure you turn this switch to the “off” position and wait at least five minutes before proceeding to step three.

How to Light the Standing Pilot Light on a Gas Furnace
How to Light the Standing Pilot Light on a Gas Furnace from www.thespruce.com

The furnace should start automatically.the furnace’s pilot light is usually positioned at the bottom of the unit by a knob.the pilot light in your gas furnace supplies heat to your home. Once the gas has had time to dissipate, turn the knob to pilot.then, hold down the reset button and bring the flame of a long lighter close to the pilot light opening. If you can’t find the ignition button, check the instruction sticker on your furnace or the the owner’s manual.

Release The Knob And Make Sure The Flame Stays On.

If you have an older gas furnace, your heating unit relies on a little blue flame known as a pilot light to ensure ignition of the burners. If your heat is on but the furnace is only blowing cool air there is a good chance you have a pilot light that is out. You need to hold down the button marked “reset” near your pilot dial.

Near The Bottom Of Your Furnace Is A Switch That Normally Says “Pilot,” “On” And “Off.” Find This Switch And Turn It To The “Off” Position.

Hold down the reset button and relight the pilot at the same time. Then, hold down the “reset” button, bringing the flame of a long lighter close to the pilot light opening. Watch the pilot light on your furnace for a few minutes to ensure it stays lit.

73 Reference Of Checking Pilot Light On Goodman Furnace In.

The furnace should start automatically.the furnace’s pilot light is usually positioned at the bottom of the unit by a knob.the pilot light in your gas furnace supplies heat to your home. This gives the thermocouple time to warm up and keep the gas valve open. Once the gas has had time to dissipate, turn the knob to pilot. then, hold down the reset button and bring the flame of a long lighter close to the pilot light opening.

Wait Five Minutes For Any Gas Remaining In The Furnace To Vent.

How to light your pilot furnace you.how to turn on pilot light furnace:however, if you suspect a gas leak or smell gas in your home, do not turn any switches on or off, and do not attempt to relight.if the. Once you are sure the pilot light is on, release your pressure on the reset button. A pilot light on a furnace can sometimes go out for no reason at all, and oftentimes all you must do is reignite the pilot.

It Is Located Near The Gas Burners And Will Usually Have A Gas Cock Or Valve Knob That Reads On, Pilot, And Off.

How to light the pilot light on a honeywell vr8200 set your thermostat to the lowest setting and unplug your furnace. Once you are sure that the pilot light is on, release your pressure on the reset button. Keep pushing in the control knob for about 20 seconds after the pilot lights.

How To Light A Pilot Light On A Furnace
Tagged on:

Leave a Reply

Your email address will not be published.